the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. product da ta sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors the connor-winfield x533 is a 3.3v crystal controlled oscillator (xo) with lvds differential outputs. the x533 is designed for use with pll systems requiring tight frequency stability vs. temperature. the use of multiplication is utilized in this oscillator design. 1 2 x533 - 333.00mhz lvds clockseries center frequency features description ordering information 3.3v operation low jitter <3ps rmstotal frequency tolerance: 100ppm temperature range: 0 to 85cdifferential lvds outputs surface mount p ackage tape and reel packaging rohs compliant / lead free 3 . 3 v s u r f a c e m o u n t 5 . 0 x 7 . 5 m m l v d s c l o c k o s c i l l a t o r x533 ds019 02 11/07/05 www.conwin.com absolute maximum ratings table 1.0 parameter units minimum nominal maximum units note storage temperature - 40 - 100 c supply voltage (vc c) - 0.5 - 7.0 vdc operating specifications table 2.0 parameter minimum nominal maximum units note center frequency (fo) 100 - 400 mhz total frequency tolerance - 100 - 100 ppm 1 operating temperature range 0 - 85 c supply voltage (vcc) 3.135 3.3 3.465 vdc supply current (icc) - - 60 ma jitter (bw=10hz to 20mhz) - - 10 ps rms jitter (bw=12khz to 80mhz) - - 3 ps rms ssb phase noise at 10hz offset - - 75 - dbc/hz ssb phase noise at 100hz offset - - 95 - dbc/hz ssb phase noise at 1khz offset - - 110 - dbc/hz ssb phase noise at 10khz offset - - 125 - dbc/hz ssb phase noise at 100khz offset - - 120 - dbc/hz input characteristics table 3.0 parameter minimum nominal maximum units note enable in put voltage (low) (vil) - - 0.3vcc vdc 2 disable input voltage (high) (vih) 0.7vcc - - vdc 2 lvds output characteristics table 4.0 parameter minimum nominal maximum units note load - - 100 ohms 3 output differential voltage (vod) 25 0 - 450 mv duty cycle at 50% level 45 50 55 % rise / fall time - 0.6 1.0 ns package characteristics table 5.0 package hermetically sealed ceramic package with grounded m etal cover. process recommendations table 6.0 solder reflow smd product suitable for convection reflow soldering. peak temperature 260 c. maximum time above 220 c, 60 seconds. notes 1.0 inclusive of calibration @ 25c, frequency stabili ty vs. temperature, control voltage (vc) = 1.65 vdc and aging for ten years. 2.0 when oscilla tor is disabled both output are in a high impedance stat e (tri - state) 3.0 vod measured with 100 ohm resistor between the true output and the com plementary output. x533m2 333m
the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. product da ta sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors 2 2 ds019 02 11/07/05 www.conwin.com e/d n/c 2 dimensional tolerance: .005 (.127mm) 100 ohm 100 ohm vod vod qq qq timing chart pin function 1 n/c 2 enable / disable 3 ground (case) 4 output q 5 comp output q 6 vcc x 5 3 3 m 2 3 3 3 m 1 2 0 c 1 5 0 c 1 8 0 c 2 6 0 c 0 2 2 0 c 3 6 0 s e c . m a x . 1 2 0 s m a x . 1 0 s 6 0 s m a x . t im e t e m p e ra tu re 2 6 0 c solder profile suggested pad layout t est curcuit package outline and dimensions pin connections
|
